16x16mm TeenyF4 Pro 1-2S Flytower F4 OSD FC w/ Buck-Boost Converter & 5A BL_S DShot600 4In1 ESC

Specification:
Flight Controller: ( Top)
Item name: TeenyF4 Pro flight controller board
Model: TeenyF4 ProProcessor: STM32F405RGT6Sensor: MPU-6000 ( connected by SPI)Firmware Version: betaflight_3.2.0_OMNIBUSF4SD
– Built-in betaflgiht OSD- Built-in Buck-Boost ConverterInput Voltage: 1-2S LipoReceiver: PPM, IBUS, SBUS, DSM2, DSMX etc.
Size: 20*20mmMounting hole: 16*16mmMount Hole Diameter: 2mm ( M2 )Weight: 2.2gApplication: for Micro FPV brushless drone

5A 4 in 1 ESC: ( Bottom )
Item Name: Teenypro 4 In 1 5A BLHeli_S ESC
Mode: Teenypro
Input Voltage: 1-2S Lipo
Con. Current: 5A
Peak Current: 7A (5S)
Firmware: BLHELI_S
Processor: SILABS EFM8BB21F16G
BEC: NO
Size: 23x27mm (includessolderpad)
Mounting Holes: 16x16mm (M2)
Weight: 2.1g
Firmware Target: BLHeli_S S_H_50_REV16_7
– Support Dshot150 Dshot300 Dshot600Oneshot125 Multishot PWM

Features:
– Support programmable LED_strip
– Support BLheli/BLHELI_S suite Pass-through ready
– Support PPM, Oneshot125,Oneshot42,Multishot, Dshot150, Dshot300, Dshot600
– Default Dshot600
– Built-in voltage detection, alarm
– Built-in Betaflight-OSD
– Buzzer solder pin
– LED_STRIP connector

Setting Notice:
– SBUS/IBUS/DSMX receiver please configure RX1 (UART1) as input, and enable Serial_RX- PPM receiver dont need to enable Serial_RX- DSM/DSM2/DSMX receiver power from 3.3V- SBUS and PPM receiver power from 5V

Package Included:
1x F4 Flight Controller Board
1x 5A 4 In 1 ESC
1x 6P Cable
8x M2*5+5 Nylon column
8x M2 Nuts
8x M2 Screw