KIT INCLUDES:

• MG996R servo motor -2
• HC-SR04 ultrasonic sensor -2
• Arduino mega with cable – 1
• 10k pot – 1
• 16×2 lcd Display – 1
• Breadboard 840 points – 1
• Jumper wires Male to male – 40 pieces
• Jumper wires male to female- 40 pieces
• 5v 1 amp adapter 1
• Single stand wire 2mt – 1

HARDWARE REQUIRED

• MG996R servo motor -2
• HC-SR04 ultrasonic sensor -2
• Arduino mega with cable – 1
• 10k pot – 1
• 16×2 lcd Display – 1
• Breadboard 840 points – 1
• Jumper wires Male to male – 40 pieces
• Jumper wires male to female- 40 pieces
• 5v 1 amp adapter 1
• Single stand wire 2mt – 1

SOFTWARE REQUIRED

Arduino IDE 1.8.5 (programmable platform for Arduino)

Click To Download :https://www.arduino.cc/en/Main/Software

SPECIFICATIONS

16*2 LCD DISPLAY

• Standard 16×2 Character LCD
• 16 Characters Wide x 2 Lines
• 5 x 8 Dots with Cursor
• Built in Controller (HD44780 or equivalent)
• +3.3V Power Supply
• Backlight Included

ULTRASONIC SENSOR

• Operating Voltage: 5V
• Static current: 2mA max
• Induction Angle: 15
• Detection Range: 2 200cm
• High precision up to 3mm

PIN DESCRIPTION

16*2 LCD DISPLAY

ULTRASONIC SENSOR

CIRCUIT CONNECTION

• Connect Servo motors negative to negative rail and positive to the positive rail
• Connect Servo 1 signal is connected to Digital pin D7 of mega and of servo 2 to Digital pinD10 of mega.
• Ultrasonic sensor’s ground to negative rail and Vcc to the positive rail
• Connect Ultrasonic sensor 1 trigger and echo to Arduino pin D19 and D20 and ultrasonic sensor 2 trigger and echo to D23 and D24 of mega
• Connect 10k pot negative and positive to negative and positive rail on breadboard and data pin to pin 3 of LCD.
• Connect Arduino ground to negative rail and 5v to the positive rail
• Connect LCD pin 1 to GND, pin 2 to 5v, pin 4 to D36 of, pin 5 to GND, pin 6 to D38, pin11 to D40, pin12 to D42, pin 13 to D44, pin 14 to D46 of mega, pin 15 to 5v and pin 16 to end.
• Connect breadboard positive to positive and negative to the negative rail

CODE

https://docs.google.com/document/d/e/2PACX-1vTz6wcAS0wvpP60UMgoKeJjErsgDrAobvbEwyiMwSPWoT_oWdOfsmR3791X47hYe9pL9FZEEzIhwUZi/pub

WORKING

The project is composed of different common components like the servo motor, ultrasonic sensor, and an output LCD Display. The complete project works in the way that all movements detected on the left door, counts the counter up, making it say that a specific number of person is inside the establishment, on the other hand, counting down signifies that this sum of persons has left the establishment.