The WIZnet W55RP20-EVB-Pico is a Pico ‘clone’ with Ethernet which houses the new W55RP20 from WIZnet – a chip combining the W5500 (a wired TCP/IP controller) and the RP2040. It works mostly** the same as Raspberry Pi Pico board but with additional Ethernet via W5500 and USB-C!

If your Raspberry Pi Pico project needs an Ethernet connection, or you simply want to evaluate this interesting new W55RP20 chip from WIZnet – this is the board for you! Bonus – the W55RP20-EVB-Pico also has a USB-C connection!

A USB-C cable isn’t included, but you can grab one here.

**The board has the same pinout as the Raspberry Pi Pico board. However, GPIO17, GPIO20, GPIO21, GPIO22, GPIO23, GPIO24, and GPIO25 are not available due to the connection inside the board. See the pinout section below for more information.

Features

• Raspberry Pi Pico clone with Ethernet
• W55RP20 microcontroller
  • Internal 2MByte Flash
  • Dual-core cortex M0+ at up to 133MHz
  • 264kByte multi-bank high performance SRAM
  • External Quad-SPI Flash with eXecute In Place (XIP)
  • High performance full-crossbar bus fabric
  • 22 multi-function General Purpose IO (4 can be used for ADC)
    • 1.8-3.3V IO Voltage (NOTE. Pico IO voltage is fixed at 3.3V)
  • 12-bit 500ksps Analogue to Digital Converter (ADC)
  • Various digital peripherals
    • 2 UART, 2 I2C, 2 I2C, 2 SPI, 16 PWM channels
    • 1 Timer with 4 alarms, 1 Real Time Counter
  • 2 Programmable IO (PIO) blocks, 8 state machines total
  • Flexible, user-programmable high-speed IO
  • Can emulate interfaces such as SD Card and VGA
  • Supports Hardwired Internet Protocols: TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
  • Supports 8 Independent Hardware SOCKETs simultaneously
  • Internal 32 Kbytes Memory for TX/ RX Buffers
  • Supports High Speed Serial Peripheral Interface(SPI MODE 0, 3)
• USB-C port for power and data (and for reprogramming the Flash)
• 3-pin ARM Serial Wire Debug (SWD) port
• 10 / 100 Ethernet PHY embedded
• Supports Auto-Negotiation
  • Full / Half Duplex
  • 10 / 100 Based
• Built-in RJ45 (POE)
• Built-in DCDC (PWM/PFM)
• Additional modules can be installed to enable POE (not included but coming soon!)

Resources

• Product Wiki
• W55RP20 DataSheet
• W5500 Datasheet
• RP2040 Datasheet
• Schematic
• Dimension drawing
• Part list & Gerber

Firmware Examples

• C/C++
  • Ethernet Examples
  • AWS Examples
  • Azure Examples
  • LwIP Examples
  • FreeRTOS Examples
• CircuitPython Examples (Coming Soon)
• MicroPython Examples (Coming Soon)

Pinout

Note: GPIO17, GPIO20, GPIO21, GPIO22, GPIO23, GPIO24, and GPIO25 are not available due to the connection inside the board.

Package Contents

• 1x WIZnet W55RP20-EVB-Pico board